The short version of melanocortin receptor fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2026-07-12 and is reviewed periodically as new material appears.
Melanotan II is a synthetic cyclic heptapeptide analogue of alpha-melanocyte-stimulating hormone, a naturally occurring peptide involved in pigmentation signalling. Its structure substitutes a lactam bridge between side chains to increase stability relative to the native hormone. The compound is also known by the shorthand MT-II and by several non-proprietary synonyms used in research catalogues. It is not an approved therapeutic product in any major jurisdiction; material sold under this name is typically offered as a laboratory reagent rather than as a medicine.
Activity is attributed to agonism at melanocortin receptors, particularly MC1R and MC4R. Activation of MC1R on melanocytes increases melanin synthesis, which underlies the reported tanning effect. MC4R engagement in the central nervous system is linked to appetite suppression and to effects on sexual arousal reported in early clinical studies. Those studies were small and were not designed to establish efficacy or long-term safety. Receptor selectivity among the melanocortin subtypes is not absolute, which complicates attribution of any effect to a single pathway.
Freeze-dried melanotan-2 is normally kept as a desiccated powder at minus twenty degrees Celsius or lower, shielded from light and moisture. Peptides of this size degrade through hydrolysis, oxidation and deamidation, and each pathway accelerates as temperature and water activity rise. Repeated freeze-thaw cycles promote aggregation and loss of material, so aliquoting a stock solution before freezing is standard laboratory practice. Once dissolved, the solution is markedly less stable than the powder. In laboratory work, solutions are generally refrigerated and used within days rather than kept for months.
Identity and purity are usually assessed by reversed-phase high-performance liquid chromatography, which separates the target peptide from truncated or oxidised impurities. Mass spectrometry, most often coupled to liquid chromatography, confirms molecular mass and detects substitutions that chromatography alone may miss. Amino acid analysis and peptide mapping supply additional structural evidence, while nuclear magnetic resonance is reserved for full structural confirmation. Laboratories that examine samples sold online report wide variation in actual content, with some vials containing little or none of the labelled material.
Melanotan-2 appears on the World Anti-Doping Agency prohibited list within the peptide hormone class, and several national regulators treat it as an unapproved prescription substance. Some countries restrict importation or sale for personal use. Because the compound is widely traded as a research chemical, the practical legal picture differs between jurisdictions and shifts over time. Human safety data covering long periods are limited, and whether repeated pigmentation changes carry any lasting risk to melanocytes remains an open question.
| Property | Value | Notes |
|---|---|---|
| Chemical class | Synthetic cyclic heptapeptide | Analogue of alpha-melanocyte-stimulating hormone |
| Common synonyms | MT-II; melanotan 2 | No internationally accepted non-proprietary name |
| Typical presentation | Lyophilised powder in a sealed vial | Often supplied alongside a separate diluent |
| Regulatory status | Unapproved therapeutic substance | Customs seizure reported in several jurisdictions |
| Reported route in use | Subcutaneous injection | Self-administered outside clinical settings |
Melanotan-2, also written Melanotan II, is a synthetic cyclic heptapeptide designed as an analogue of alpha-melanocyte-stimulating hormone. Its sequence is Ac-Nle-cyclo[Asp-His-D-Phe-Arg-Trp-Lys]-NH2, and the lactam bridge between the aspartate and lysine side chains constrains the peptide into a ring. This structural change increases receptor affinity and metabolic stability relative to the native hormone. The compound was created in the 1980s as a research tool for studying pigmentation biology.
Melanocytes are the pigment-producing cells of the skin, and they carry melanocortin-1 receptors on their surface. When the receptor is activated, cyclic adenosine monophosphate rises inside the cell and raises the activity of enzymes such as tyrosinase, which increases melanin output. Melanotan-2 binds melanocortin-1 receptors in vitro and in animal models, and this binding is generally described as the basis for the tanning effect. Other receptors account for different effects: melanocortin-4 receptors contribute to appetite and erectile signalling, while melanocortin-3 and melanocortin-5 receptors contribute to energy balance and exocrine function.
The peer-reviewed record is dominated by small early-phase studies, case reports and pharmacovigilance summaries rather than large randomised trials. Papers typically examine tanning response, receptor selectivity or patterns of reported adverse events. Many note that participants obtained the peptide outside a clinical setting, which limits verification of composition and administered amount. Reported events vary widely, and causality is frequently unclear because the identity and purity of self-sourced material are unknown. Open questions include whether repeated melanocortin receptor stimulation produces cumulative effects, and how often label claims match actual content.
Identification in laboratories relies on reversed-phase liquid chromatography coupled with tandem mass spectrometry, with product-ion spectra compared against a certified reference standard. High-resolution mass spectrometry supplies accurate mass confirmation, and peptide mapping after enzymatic digestion separates melanotan II from closely related analogues. Quantitation of seized material is complicated by unknown counter-ions and residual trifluoroacetate left from purification. Immunoassays raised against alpha-melanocyte-stimulating hormone can cross-react, so chromatographic confirmation is normally required. Urinary detection windows are short, and reported limits of detection differ substantially between laboratories.
Structurally, Melanotan-2 retains the core recognition motif of alpha-melanocyte-stimulating hormone while adding a lactam bridge that links two side chains and constrains the molecule into a ring. This modification lowers susceptibility to enzymatic degradation. The compound acts as an agonist at melanocortin receptors, particularly subtypes associated with melanin production. Because the same receptor family influences several physiological processes, researchers note that its activity is not confined to pigmentation alone. Receptor selectivity continues to be examined in published studies.
Melanotan-2 is a synthetic cyclic heptapeptide designed as an analogue of alpha-melanocyte-stimulating hormone, a naturally occurring peptide involved in pigmentation signalling. Its sequence incorporates modified residues that increase potency and extend biological activity relative to the native hormone. The compound binds receptors of the melanocortin family and is examined mainly in laboratory research. It does not occur naturally and exists only as a manufactured chemical entity produced by solid-phase synthesis.
The peptide was developed during the 1980s by researchers investigating melanocortin signalling and skin pigmentation pathways. Early work focused on analogues of alpha-melanocyte-stimulating hormone that would resist enzymatic breakdown more effectively than the parent molecule. Melanotan-2 emerged from that programme as a shortened, cyclised variant. Reports describing its synthesis and receptor activity later appeared in the scientific literature. Commercial availability grew through unregulated channels rather than through pharmaceutical approval.
Identity and purity are assessed mainly by reversed-phase high-performance liquid chromatography with ultraviolet detection, often paired with mass spectrometry. Retention time supports identity, while the mass spectrum confirms the molecular weight of the intact peptide. Purity is frequently reported as a percentage of total peak area, a figure that depends on the wavelength, column and gradient used. Impurity profiling may also look for truncated sequences, oxidised forms and residual counterions. Amino acid analysis and peptide mapping provide orthogonal confirmation when required.
Regulatory status varies by jurisdiction, and the substance is frequently described as unapproved for therapeutic use. Some authorities classify it alongside prescription-only medicines or controlled categories, while others address it through general consumer protection rules. Analytical surveys have reported mismatches between label claims and measured content in products sold online, although the scope of such testing is limited. Whether these discrepancies are widespread remains an open question. Discussion in the literature therefore tends to combine chemistry, supply-chain observation and policy analysis.
Agarose gel matrix is often used for protein purification, for example, in column-based preparative scale separation as in gel filtration chromatography, affinity chromatography and ion exchange chromatography. It is however not used as a continuous gel, rather it is formed into porous beads or resins of varying fineness. The beads are highly porous so that protein may flow freely through the beads. These agarose-based beads are generally soft and easily crushed, so they should be used under gravity-flow, low-speed centrifugation, or low-pressure procedures. The strength of the resins can be improved by increased cross-linking and chemical hardening of the agarose resins, however such changes may also result in a lower binding capacity for protein in some separation procedures such as affinity chromatography. Agarose is a useful material for chromatography because it does not absorb biomolecules to any significant extent, has good flow properties, and can tolerate extremes of pH and ionic strength as well as high concentration of denaturants such as 8M urea or 6M guanidine HCl. Examples of agarose-based matrix for gel filtration chromatography are Sepharose and WorkBeads 40 SEC (cross-linked beaded agarose), Praesto and Superose (highly cross-linked beaded agaroses), and Superdex (dextran covalently linked to agarose). For affinity chromatography, beaded agarose is the most commonly used matrix resin for the attachment of the ligands that bind protein. The ligands are linked covalently through a spacer to activated hydroxyl groups of agarose bead polymer.
=== Consumable-free thermal modulation === This approach eliminates the need for liquid nitrogen for thermal modulation. The system employs a closed cycle refrigerator/heat exchanger to produce −90 °C at the jet. The cooling is done by indirect cooling of gaseous nitrogen (or air) and therefore is capable of modulating volatile and semi volatile compounds over the C7+ range.
Ribosomal RNA organizes into two types of major ribosomal subunit: the large subunit (LSU) and the small subunit (SSU). One of each type come together to form a functioning ribosome. The subunits are at times referred to by their size-sedimentation measurements (a number with an "S" suffix). In prokaryotes, the LSU and SSU are called the 50S and 30S subunits, respectively. In eukaryotes, they are a little larger; the LSU and SSU of eukaryotes are termed the 60S and 40S subunits, respectively. In the ribosomes of prokaryotes such as bacteria, the SSU contains a single small rRNA molecule (~1500 nucleotides) while the LSU contains one single small rRNA and a single large rRNA molecule (~3000 nucleotides). These are combined with ~50 ribosomal proteins to form ribosomal subunits. There are three types of rRNA found in prokaryotic ribosomes: 23S and 5S rRNA in the LSU and 16S rRNA in the SSU. In the ribosomes of eukaryotes such as humans, the SSU contains a single small rRNA (~1800 nucleotides) while the LSU contains two small rRNAs and one molecule of large rRNA (~5000 nucleotides). Eukaryotic rRNA has over 70 ribosomal proteins which interact to form larger and more polymorphic ribosomal units in comparison to prokaryotes. There are four types of rRNA in eukaryotes: 3 species in the LSU and 1 in the SSU. Yeast has been the traditional model for observation of eukaryotic rRNA behavior and processes, leading to a deficit in diversification of research.
Sources: en.wikipedia.org
Splenectomy (operative): This is the operative removal of the entire spleen by a surgeon, thus stopping the extravascular hemolysis, but also removing the immune functions that the spleen naturally provides to the body. Partial splenectomy (operative): This is when only a section of the spleen is removed, instead of the entire organ. The goal is to lower the extravascular hemolysis to a level compatible with homeostasis of the patient, while preserving the immune function of the spleen's presence. Research on outcomes is currently ongoing, and is routine at children's hospitals within the United States of America. Splenic ablation (interventional radiology): This option is non-operative, and is when an interventional radiologist (instead of a surgeon) uses radiologic techniques to coil or cauterize vasculature within the splenic circulation. There are various points in the circulatory pathway where the treatment can be applied to produces varying amounts of retained viability of the spleen, thus giving the option to attempt to preserve splenic immune function. All operative and interventional treatments require the immunization of HS patients against the influenza virus, SARS-CoV-2, and encapsulated bacteria such as Streptococcus pneumoniae and meningococcus. Antibiotics are no longer recommended for maintenance use, even in post-splenectomy HS patients. Since the spleen is important for protecting against encapsulated organisms, sepsis caused by encapsulated organisms is a possible complication of splenectomy. Additional elective treatments offered:
== History == The original interface between capillary zone electrophoresis and mass spectrometry was developed in 1987 by Richard D. Smith and coworkers at Pacific Northwest National Laboratory, and who also later were involved in development of interfaces with other CE variants, including capillary isotachophoresis and capillary isoelectric focusing.
=== Market Share === Tetra Pak has occasionally been subject to controversy, most notably regarding its near-monopoly position on certain markets for many years. Especially attempts at mergers have been subject to scrutiny. Its merger with French PET-production company Sidel in 2001 drew anti-competition allegations from the European Commission. The court case was drawn out for many years and twice appealed to the European Court of First Instance before the European Court of Justice ruled in favour of Tetra Laval. In 2004, Tetra Pak was accused of using its near-monopoly in China, where it owned 95 percent of the market for aseptic carton packaging. The allegations were contested by Tetra Pak.
Sources: en.wikipedia.org
No. No major regulatory agency has granted a marketing authorisation for melanotan II as a medicine. Products sold under this name are generally presented as laboratory reagents and are not subject to the batch-release testing applied to approved drugs.
It was developed in the 1980s by researchers investigating analogues of alpha-melanocyte-stimulating hormone for pigmentation and related endpoints. Early work included small human studies during the 1990s. Development did not progress to licensing, and the compound remained a research and grey-market item.
Peptides are prone to truncation, oxidation and aggregation during synthesis and handling. Without independent testing, a buyer cannot confirm the identity or the content of a vial. Analytical surveys of unapproved peptide products have repeatedly found discrepancies between label claims and measured composition.
The lyophilised solid is best kept cold, dry and dark, typically at minus twenty degrees Celsius. Moisture and repeated warming cycles are the main causes of degradation. Solutions prepared from the powder are less stable and are normally used quickly.