If you have been reading about alpha-MSH analogue and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Last reviewed on 2026-03-02. Where a claim depends on a specific study, the study is described rather than over-claimed.
Melanotan II is a synthetic peptide analog modeled on alpha-melanocyte-stimulating hormone, a naturally occurring signaling peptide involved in pigmentation. Its structure is a cyclic heptapeptide containing two non-natural substitutions, norleucine at position four and D-phenylalanine at position seven. These modifications resist enzymatic breakdown and extend the molecule's activity relative to the native hormone. The compound binds melanocortin receptors and is studied mainly as a pharmacological tool rather than a therapeutic product. It has never received approval as a medicine in any major jurisdiction.
The compound was developed in the late 1980s and 1990s by academic researchers investigating photoprotection. The rationale held that stimulating melanin production might reduce ultraviolet damage to skin and lower skin cancer risk. Early work examined receptor binding, pigment response, and short-term tolerability in small studies. That program did not produce an approved drug, and formal development stalled after early-phase trials. Whether induced pigmentation confers meaningful photoprotection remains an open question.
Melanotan-2 is handled in the laboratory as a lyophilised powder that dissolves readily in water, dimethyl sulfoxide and dimethylformamide, with limited solubility in ethanol. Stock solutions prepared in an organic solvent often precipitate when diluted into aqueous buffer, so gradual dilution with mixing is standard practice. The peptide carries a tryptophan residue and a histidine residue, both sensitive to oxidation and to alkaline conditions. Working solutions are therefore kept near neutral to slightly acidic pH, protected from light, and consumed within the same working session whenever that is practical.
Solid peptide kept dry at minus twenty degrees Celsius, shielded from light and moisture, is generally considered stable for extended periods. Solutions are divided into single-use aliquots and held at minus twenty or minus eighty degrees Celsius, because repeated freeze-thaw cycles promote aggregation and loss of material to container surfaces. Hydrolysis of the backbone and oxidation of tryptophan are the principal degradation routes in aqueous solution, and both accelerate at ambient temperature. Hygroscopic uptake after a vial is opened can also shift the actual mass weighed, which affects any concentration calculated from it.
Routine characterisation relies on reversed-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres, using a C18 column and a water-acetonitrile gradient containing trifluoroacetic acid. Electrospray ionisation mass spectrometry confirms the expected molecular mass and can reveal truncated or oxidised by-products that co-elute poorly. Sequence and stereochemistry require additional work, such as peptide mapping or amino acid analysis, because a chromatographic purity figure alone does not distinguish a diastereomer from the target peptide. Independent testing of research-grade material frequently shows measured content below the stated label, so a certificate of analysis is best read together with the method that produced it.
| Property | Value | Notes |
|---|---|---|
| Chemical class | Synthetic cyclic heptapeptide | Belongs to the melanocortin agonist family |
| Key substitutions | Nle4 and D-Phe7 | Improve resistance to enzymatic degradation |
| Molecular formula | C50H69N15O9 | Approximately 1024 g/mol |
| Regulatory status | Not approved as a medicine | Distributed as a research chemical |
| Common synonyms | Melanotan II, MT-II, MT-2 | Spelling varies across sources |
Melanotan-2 is a synthetic cyclic heptapeptide designed as an analogue of alpha-melanocyte-stimulating hormone, a naturally occurring peptide involved in pigmentation signalling. Its sequence incorporates modified residues that increase potency and extend biological activity relative to the native hormone. The compound binds receptors of the melanocortin family and is examined mainly in laboratory research. It does not occur naturally and exists only as a manufactured chemical entity produced by solid-phase synthesis.
The peptide was developed during the 1980s by researchers investigating melanocortin signalling and skin pigmentation pathways. Early work focused on analogues of alpha-melanocyte-stimulating hormone that would resist enzymatic breakdown more effectively than the parent molecule. Melanotan-2 emerged from that programme as a shortened, cyclised variant. Reports describing its synthesis and receptor activity later appeared in the scientific literature. Commercial availability grew through unregulated channels rather than through pharmaceutical approval.
Identity testing for a synthetic peptide relies on several complementary methods. Reversed-phase high-performance liquid chromatography separates the target from related impurities and reports purity as a percentage of total peak area. Mass spectrometry confirms molecular mass and can reveal deletions or truncations. Amino acid analysis and peptide mapping provide sequence-level confirmation, while counter-ion content and residual solvents are measured separately. A purity figure alone does not establish identity, so a complete dataset combines chromatographic and spectrometric evidence.
Lyophilized peptide powder is generally stored frozen, protected from light and moisture. Tryptophan residues are susceptible to oxidation, and the lactam bridge can hydrolyze under strongly acidic or basic conditions. Solutions prepared for laboratory work degrade faster than dry powder, and repeated freeze-thaw cycles accelerate loss. Common practice is to aliquot solutions before freezing and to avoid alkaline buffers. Reported stability windows vary with concentration, buffer, and temperature, so exact shelf lives are method-specific rather than universal.
The compound emerged from research programs in the 1980s that examined analogues of alpha-melanocyte-stimulating hormone for pigmentation and photoprotection. Investigators modified the native sequence to extend activity duration and potency. A related analogue, afamelanotide, was developed within the same broad line of inquiry and eventually gained approval in certain jurisdictions for a rare light-sensitivity condition. Melanotan-2 itself did not progress through the same regulatory route and has no approved therapeutic indication.
Melanocortin receptors comprise five subtypes with distinct tissue distributions and functions. Melanotan-2 is described in the literature as a non-selective agonist that engages several of these subtypes, including MC1R, MC3R, MC4R, and MC5R. MC1R is the subtype most directly linked to melanin production in skin cells. Because the compound is not subtype-selective, its observed effects in experimental settings are generally attributed to activity across multiple receptor pathways rather than to a single target.
Regulatory treatment varies by country. In the United States the peptide is not approved as a medicine, and products offered for human use may be treated as unapproved new drugs; some states also restrict sale. Australia, the United Kingdom, and European Union member states apply comparable restrictions to unapproved peptide products. Border agencies have seized shipments labelled as research chemicals. Classification may change over time, and the legal position for personal importation is not clearly settled in most published guidance.
Lyophilised melanotan-2 is supplied as a solid, which is more stable than a solution. The material is hygroscopic, so weighing is done quickly, in low humidity, with the container kept sealed. Reconstitution usually uses water for injection or bacteriostatic water, added down the wall of the vial to limit foaming. A reconstituted solution is held at 2 to 8 °C and kept away from light. Repeated freezing and thawing of the same vial is avoided because ice crystal formation and concentration effects degrade the peptide.
Reversed-phase high-performance liquid chromatography is the routine method for purity assessment. Peptides absorb near 214 nm because of the peptide bond, and a gradient of acetonitrile in water separates the intact peptide from deletion sequences, oxidised products, and earlier-eluting fragments at neutral pH. Electrospray ionisation mass spectrometry provides an orthogonal check: the measured mass must agree with the theoretical value. Amino acid analysis and peptide mapping confirm structure but are used less often. Reference standards remain scarce because the peptide is not described in any pharmacopoeia.
In contrast to oral estradiol, due to the lack of the first pass, an excess in estrone and estrogen conjugate levels does not occur with transdermal estradiol or other parenteral estradiol routes. The transformation of estradiol into estrone and estrogen conjugates is reversible. As such, these metabolites can be converted back into estradiol. About 15% of orally administered estradiol is transformed into estrone and 65% into estrone sulfate. About 5% of estrone and 1.4% of estrone sulfate is converted back into estradiol. An additional 21% of estrone sulfate is converted into estrone, whereas transformation of estrone into estrone sulfate is approximately 54%. The interconversion between estradiol and estrone is mediated by 17β-hydroxysteroid dehydrogenases (17β-HSDs), whereas the conversion of estrone into estrone sulfate is mediated by estrogen sulfotransferases (ESTs) and the transformation of estrone sulfate into estrone by steroid sulfatase (STS). The metabolic clearance rates and hence blood half-lives of estrogen conjugates like estrone sulfate are much longer than those of estradiol and estrone. Estrogen conjugates, primarily estrone sulfate, serve as a large circulating reservoir for estradiol, and because of this, they function to greatly extend the biological half-life of oral estradiol. As such, the biological half-life of oral estradiol is a composite parameter that is dependent on interconversion between estradiol and estrogen conjugates, as well as on enterohepatic recirculation.
== Medical use == Branched-chain alpha-keto acids such as α-KIC are found in high concentrations in the urine of people who suffer from Maple Syrup Urine Disease. This is disease is caused by a partial branched-chain alpha-keto acid dehydrogenase deficiency, which leads to a buildup of branched-chain alpha-keto acids, including α-KIC and HMB. These keto-acids build up in the liver, and since limited isovaleryl-CoA can be produced, these keto-acids must be excreted in the urine as α-KIC, HMB, and many other similar keto acids. Flare-ups in people who have this condition are caused due to poor diet. Symptoms of Maple Syrup Urine Disease include sweet smelling urine, irritability, lethargy, and in serious cases edema of the brain, apnea, coma, or respiratory failure. Treatment includes lowering leucine intake and a specialized diet to make up for the lack of leucine ingestion.
== See also == Alleged Libyan financing in the 2007 French presidential election Disarmament of Libya Egyptian–Libyan War History of Libya under Muammar Gaddafi HIV trial in Libya Libya and weapons of mass destruction List of heads of state and government deposed by foreign powers in the 20th and 21st century List of heads of state and government who were assassinated or executed List of state leaders who died in office Pan Am Flight 103 SNC-Lavalin affair UTA Flight 772 West Berlin discotheque bombing
Sources: en.wikipedia.org
==== Household dust ==== PFOA is frequently found in household dust, making it an important exposure route for adults, but more substantially, children. Children have higher exposures to PFOA through dust compared to adults. Hand-to-mouth contact and proximity to high concentrations of dust make them more susceptible to ingestion, and increases PFOA exposure. One study showed significant positive associations were recognized between dust ingestion and PFOA serum concentrations. However, an alternate study found exposure due to dust ingestion was associated with minimal risk.
X-ray crystallography studies have been performed to determine the structure of aspartate transaminase from various sources, including chicken mitochondria, pig heart cytosol, and E. coli. Overall, the three-dimensional polypeptide structure for all species is quite similar. AST is dimeric, consisting of two identical subunits, each with approximately 400 amino acid residues and a molecular weight of approximately 45 kD. Each subunit is composed of a large and a small domain, as well as a third domain consisting of the N-terminal residues 3–14; these few residues form a strand, which links and stabilizes the two subunits of the dimer. The large domain, which includes residues 48–325, binds the PLP cofactor via an aldimine linkage to the ε-amino group of Lys258. Other residues in this domain—Asp222 and Tyr225—also interact with PLP via hydrogen bonding. The small domain consists of residues 15–47 and 326–410 and represents a flexible region that shifts the enzyme from an "open" to a "closed" conformation upon substrate binding. The two independent active sites are positioned near the interface between the two domains. Within each active site, a couple arginine residues are responsible for the enzyme's specificity for dicarboxylic acid substrates: Arg386 interacts with the substrate's proximal (α-)carboxylate group, while Arg292 complexes with the distal (side-chain) carboxylate. In terms of secondary structure, AST contains both α and β elements. Each domain has a central sheet of β-strands with α-helices packed on either side.
In addition, Kuwait had been producing oil above treaty limits established by OPEC. By the eve of the Iraqi invasion, Kuwait had set production quotas to almost 1.9 million barrels per day (300,000 m3/d), which coincided with a sharp worldwide drop in the price of oil. By the summer of 1990, Kuwaiti overproduction had become a serious point of contention with Iraq. Some analysts have speculated that one of Saddam Hussein's main motivations in invading Kuwait was to punish the ruling al-Sabah family in Kuwait for not stopping its policy of overproduction, as well as his reasoning behind the destruction of said wells. It is also hypothesized that Iraq decided to destroy the oil fields to achieve a military advantage, believing the intense smoke plumes serving as smoke screens created by the burning oil wells would inhibit Coalition offensive airstrikes, foil allied precision guided weapons and spy satellites, and could screen Iraq's military movements. Furthermore, it is thought that Iraq's military leaders may have regarded the heat, smoke, and debris from hundreds of burning oil wells as presenting a formidable area denial obstacle to Coalition forces. The onset of the oil well destruction supports this military dimension to the sabotage of the wells; for example, during the early stage of the Coalition air campaign, the number of oil wells afire was relatively small but the number increased dramatically in late February with the arrival of the ground war.
Sources: en.wikipedia.org
It is a synthetic cyclic peptide designed as an analog of alpha-melanocyte-stimulating hormone. It acts on melanocortin receptors and is best known from research into pigmentation. It is not an approved pharmaceutical product.
No regulatory agency has approved it for any indication. It is encountered as a research chemical sold outside pharmaceutical supply chains. Products marketed this way are not subject to the manufacturing and labeling requirements that apply to approved drugs.
Reports describe increased skin pigmentation as well as side effects such as nausea, flushing, and changes to existing moles. Much of the evidence comes from small studies and case reports rather than large trials. The long-term safety profile is therefore uncertain.
Purity is normally stated as an area percentage from high-performance liquid chromatography, for example ninety-five or ninety-eight percent. That figure describes the proportion of ultraviolet-absorbing material eluting as the main peak. It says nothing about water content, counterions, residual solvents or mass fraction of the peptide itself.